Opticis Point to Point Hybrid DVI Cable - 20m/68ft (M1-1P0E-020)

The M1-1P0E-020 DVI extension cable is a new member of the Opticis family of products that stretches your digital visual interface connectivity. The M1-1P0E-020 is a hybrid cable solution using four H-PCF (Hard-Polymer Clad Fibre) or multi-mode glass fibers for the Red, Green, Blue and Clock high- speed digital graphic signals and copper wires for the low frequency DDC / HDCP control signals, wrapped in a PVC jacket.
Length: 20 meter / 68 feet
Part Number: M1-1P0E-020

The reality of gigabit high-speed digital graphic interconnections mandates products that maintain front-of-screen video quality. Optical technology extends the ability to transmit digital graphic data beyond the physical limits of copper wires by, i) providing pure signal integrity over long distances for the optimum visual experience, ii) no EMI/RFI transmission or reception, iii) light weight, rugged cabling and connectors, iv) very cost effective per foot/metre, v) low power consumption, and vi) plug and go installation ease – no software requirements.
The product consists of a transmitter and a receiver, which are connected by bundled optical fibre and copper cables. There are male DVI-D connectors at each end. The high-speed graphic data transmission is accomplished by using a VCSEL array inside the transmitter connector, and a Pin-PD array inside the receiver connector.

Features:

• Extend digital graphic signals up to 100m (330ft) with no signal degradation.
• Supports up to WUXGA (1920x1200) resolution at 60Hz refresh rate.
• Complies with DVI standard (165Mpixels/sec maximum) and supports DDC2B mode.
• Complies with HDMI standard supporting HDCP parameters.
• Uses the PC host +5V source from the video card DVI pin number 14 to drive the Tx and Rx modules, assuming a minimum of 500mA is available from the PC.
• Auto power switching circuit offers an option of whether to use an AC/DC power adapter depending on power supply capability of PC graphic card.
• The transmitter (Tx) module is designed to protect the conflict of power supply between the external DC power adapter and PC.
• Connectors are compact and light enough to directly plug into the graphic controller card and panel display.
• Data security inherent with fiber and no RFI/EMI emissions.
• No software required; plug and play.